Scooter / Moto
- Carte Cadeaux
- Pièces Ouvertes / Usagées
-
Yamaha
- Zuma X 50 (4T) 2012+
- Bws-Zuma 50F (4T) 2012+
- Bws-Zuma 50 (2T) 02-11
- Bwsr-Zuma 50 (2T) 88-02
- Jog 50 Horizontal (2T) 91-01
- Aerox 50 (2T) 99-02
- Aerox 50 (2T) 03-13
- Aerox 50 (4T) 2014+
- C3 Cube 50 (4T)
- Bws 100 (2T)
- Bws-Zuma 125 (4T)
- Vino 50 (4T) 06-15
- Vino 50 (2T) 01-05
- Morphous 250 (4T)
- Majesty 400 (4T) 04-08
- T-Max 500
- Yamaha R3 2015
- Yamaha Tmax 530
-
Honda
- Honda Ruckus
- Honda Ruckus GY6
- Honda Navi 110 2022+
- Honda Grom MSX 125 14-16
- Honda Grom MSX 125 17-21
- Honda Grom MSX 125 2022+
- Honda Dio 50 (CA) AF18
- Honda Elite 94+ AF16
- Honda Elite 87-93 AF05
- Honda Aero AF05
- Honda Dio ZX 50 (Horizontal)
- Honda Metropolitan-Jazz CHF50
- Honda Giorno NCH50 (EFI)
- Honda Metropolitan NCH50 (EFI)
- Honda SH 150 04-12
- Honda SH 150 2013+
- Honda CBR 125R 04-06
- Honda CBR 125R 06-10
- PGO
- Genuine
- Vento
- E-Ton
- Adly
-
Kymco
- Kymco ZX Super Fever 50cc
- Kymco Vitality 50 AC (2T)
- Kymco Super8 50 AC (2T)
- Kymco Super9 50 AC (2T)
- Kymco Super9 50 LC (2T)
- Kymco People 50 AC (2T)
- Kymco Agility 50 (4T)
- Kymco Like 50 (4T)
- Kymco People S 50 (4T)
- Kymco Sento 50 (4T)
- Kymco Agility 125 (4T)
- Kymco Bet&Win 125 (4T)
- Kymco Grand Dink 125 (4T)
- Kymco Like 125 (4T)
- Kymco People S 125 (4T)
- Kymco Super 8 125 (4T)
- Kymco Agility 150 (4T)
- Kymco People 150 (4T)
- Kymco Grand Dink 150 (4T)
- Kymco Super 8 150 (4T)
- CPI
- Malaguti
- Derbi
- Piaggio
-
Vespa
- Vespa LX 50 (4T)
- Vespa LX 50 4V (4T)
- Vespa LX 50 (2T)
- Vespa Primavera 50 4V (4T)
- Vespa S 50 (4T)
- Vespa S 50 4V (4T)
- Vespa S 50 (2T)
- Vespa Sprint 50 4V (4T)
- Vespa ET4 50 (4T)
- Vespa ET2 50 (2T)
- Vespa 946 125-150 IE 3V (4T)
- Vespa LX 125-150 IE 3V (4T)
- Vespa LX 125-150 Carb (4T)
- Vespa LX 125-150 IE (4T)
- Vespa LXV 125-150 IE (4T)
- Vespa Primavera 125 3V iGet (4T)
- Vespa Primavera 150 IE 3V (4T)
- Vespa S 125-150 3V IE (4T)
- Vespa S 125-150 Carb (4T)
- Vespa Sprint 125-150 3V IE (4T)
- Vespa Sprint 125 IE 3V iGet (4T)
- Vespa ET4 125-150 Carb (4T)
- Vespa GTS 125-150 (4T)
- Vespa GT 200
- Vespa GTS 250
- Vespa GTS 300 IE (4T)
- Vespa GTV 250
- Vespa GTV 300
- Sym
- Wolf
- Aprilia
- TGB
- Kawasaki
- Keeway
- Hyosung
Accessoires
Mini Quad / UTV
Type de Moteur
Roues Customs
Engine Swap Harness PSP Honda Ruckus GY6
TRS-HRGWH/PSP
Nouveau
Le harnais de moteur GY6 plug and play ATR éliminera le besoin de faire du bruit avec le câblage de vos permutations de moteur! Réduisez les risques d'erreurs et de problèmes. Pré-étiqueté et prêt à partir!
En savoir plus
ATR plug and play GY6 engine harness will eliminate the need to fuzz around with wiring your engine swaps! Reduce the chances of errors and problems. Pre-labeled and ready to go! INCLUDES : LABELED HARNESS, CDI, COIL, RECTIFIER/REG
COMES WITH GY6 CDI TOO
WE DO RECOMMEND TO GET THE 11 POLE STATOR. THIS HARNESS IS MEANT FOR 11 POLE STATOR ONLY
99% plug and play. You will need to use your stock OEM ignition plug of your Ruckus or we have replacements here : 3-position Female Ignition plug
Some times the pins come undone on the ICE CUBE CLEAR RELAY here’s where they go
IF YOU WANT TO USE 12MM SWITCH FOR A KILL SWITCH
YOU WILL NEED A STANDARD 20/30AMP 12V RELAY AND HERE’S THE LAYOUT
KILL SWITCHAND START BUTTON ATR WIRING
GREEN AND WHITE/BLACK TRACER ARE THE KILL SWITCH JUMP THESE WIRES IF YOU ARE USING A THROTTLE TUBE WITH NO KILL SWITCH
START BUTTON IS GREEN/YELLOW AND YELLOW/RED TRACER USE A MOMENTARY BUTTON FOR THESE SUCH AS OUR 12MM SWITCH OR OUR BATTERY BOX BLOCK OFF WITH SWITCH
WANT TO CONVERT LIGHTS TO DC SO THEY ARE BRIGHT WHEN YOU TURN THE KEY ON.
MAKE SURE ALL GROUNDS ARE GOOD. IF YOU HAVE POWDER COATED BOTH FRAMES. PLEASE REMOVE COAT OR PAINT WHERE THE TWO FRAMES MEET FOR PROPER GROUND. ALSO DON’T FORGET TO GROUND THE STOCK OEM GREEN HEADLIGHT HARNESS. MOST ISSUES NO START ISSUES ARE FROM POOR OR NO GROUND.
HOOKING UP THE FUEL SENDING UNIT
1) Connect the fuel sending unit to the ATR wire harness. Reusing the OEM connector is recommended, so you will have to cut it off of the OEM harness and put it into the ATR harness. Connect the two color coordinated wires ([Sender] Blue/White to [ATR Harness] Blue/White, [Sender]Green/black to [ATR Harness]Green).
2) Connect LED drive unit. This is the black box under the 2 indicator lights. Plug the Fuel Indicator light to the LED drive unit, then plug the large connector on the LED drive unit to the ATR Harness.
3) Connect the OEM resistor (located under the OEM ECU that was removed). Connect this to the resistor connector on the ATR harness.
If using the 5 pin rectifier that comes with the harness and you didn’t buy from us with an 8-pole stator. You must cut off plug on 5 pin rectifier and hard wire. We HIGHLY RECOMMEND GETTING AN 11 POLE STATOR FOR BETTER CHARGING AND USING THE 5 PIN RECTIFIER.
Red from Jumper to red on Rectifier
Green From jumper to Green on Rectifier
Pink from Jumper to Yellow on rectifier(use position where they would have gone if you did not use jumper)
Yellow from Jumper to Yellow on rectifier(use position where they would have gone if you did not use jumper)
You will have an extra yellow that can be cut once tested.
Since other rectifiers may different from manufacturer to manufacturer we recommend you either purchase and 11 pole Stator to swap in the motor.
Stock Left Connector — Stage 6 or
Black ———— brown (The power of Horn switch )
Light Green ——- yellow (Horn)
Black/Brown —— purple (Power to hi/low beam)
White ———– green (Low Beam)
Blue ————- grey (High Beam)
Orange ———– red (Left blinker)
Light Blue ——– black (Right Blinker)
Gray ———— orange (power to blinker Switch)
ATR Left Connector — Stage 6 or Mini Switch
Black ———— brown
Light Green ——- yellow
Yellow —— purple (This is the FEED wire to the headlights if you are running LED light you must plug in 12v DC and cap off yellow)
Yellow/white ———– green
Blue/white ————- grey
Orange ———– red
Light Blue ——– black
Gray ———— orange
ATR Left Connector — V3left switch
Black ———— Green (horn power)
Light Green ——- Light Green (horn)
Yellow —— Blue/White. This is the FEED wire to the headlights if you are running LED light you must plug in 12v DC and cap off yellow)
Yellow/white ———– White (Low Beam)
Blue/white ————- Solid Blue (High Beam)
Orange ———– Light Blue (Left Blinker) We know it opposite
Light Blue ——– Orange (Right Blinker)
Gray ———— Grey (Blinker Relay)
Stock Right Connector — Stage6
The right throttle have 2 wires that go to one button on the handle. You can have it wired to turn over the engine.
yellow w/black==red
green w/yellow==white
The kill switch can be jumped using a piece of wire
black w/white
black w/red
ATR Right Connector — Stage6
The right throttle have 2 wires that go to one button on the handle. You can have it wired to turn over the engine.
green==red
green w/yellow==white
The kill switch can be jumped using a piece of wire
White/ black tracer
Yellow w/red
Les clients qui ont acheté ce produit ont également acheté...
-
Démarreur Electrique for GY6 125-150cc
CAD$ 58.99
-
Gasket de Tête pour Cylindre GY6 150cc
CAD$ 4.99
-
Support de Moteur TRS 8" Wide Wheel pour Honda Ruckus...
CAD$ 436.99
-
Embrayage NCY Performance Gen4 GY6 125/150cc
CAD$ 77.99
-
Filtre à Air Uni 30° (52mm)
CAD$ 33.99